User manual

5. Base Specifications Parameters
63
# Items Details
Setting range (unit)
21101 add01
(bit0)
PLC axis
rapid
traverse
mode
acceleration/
deceleration
type
Select the PLC axis rapid traverse mode acceleration/
deceleration type.
(This is compatible from software version C0 and
higher.)
0: Select constant time constant acceleration/
deceleration
1: Select constant inclination acceleration/
deceleration
(Note) This parameter cannot be used when the
peripheral axes (MC1K I/F) is used.
0/1
add01
(bit1)
PLC axis
cutting feed
mode
acceleration/
deceleration
type
/Peripheral
axis (MC1K
I/F)
acceleration/
deceleration
type
Select the PLC axis cutting feed mode acceleration/
deceleration type.
(This is compatible from software version C0 and
higher.)
0: Select constant time constant acceleration/
deceleration
1: Select constant inclination acceleration/
deceleration
(Note) Select the peripheral axis (MC1K I/F)
acceleration/deceleration type when the
peripheral axes are used.
(This is compatible from software version C0
and higher.)
0/1
add01
(bit2)
Circular
command
block overlap
valid
Validates the block overlap at the circular command.
(This is compatible from software version C1 and
higher.)
0: Invalid
1: Valid
0/1
add01
(bit3)
G31
automatic
acceleration/
deceleration
Validates dry run, override and automatic acceleration/
deceleration for the G31 (skip) command.
(This is compatible from software version C1 and
higher.)
0: Invalid
1: Valid
0/1
add01
(bit4)
Reserved for system. 0
add01
(bit5)
Reserved for system. 0