System information
9
2.7. UP command and update supporting command
Update supporting command is reserved once when command receiving, and executes after UP
command receiving.
01UP¥r
01UP¥r
01Pmute_1¥r
displayExternal controller
01Pmute_1¥r
Direction of picture mute ON. It
doesn’t execute at this moment.
01Calldisp_5¥r
01Calldisp_5¥r
01Pmute_0¥r
01Pmute_0¥r
01UP¥r
01UP¥r
Direction of display memory 5
calling. It doesn’t execute at this
moment.
Direction of update. It executes
picture mute ON and display
memory 5 calling in the same time.
Direction of picture mute OFF. It
doesn’t execute at this moment.
Direction of update. It executes
picture mute OFF.
Fig. 2.2
When you obtain current setting values with skipping arguments etc., update supporting commands
doesn’t require UP command issuing. If you obtained it before UP command receiving, the obtained
value is reserved setting value.
2.8. Notice
When you issue adjustment commands, the Power State should be “Power on state” and Input signals
used for adjustment should be displayed. (It is necessary to choose an input port by “Pinp” command
etc. before adjustment.)
There are three Types of commands. It can be used when the input ports of main unit is chosen, what
can be used when the input port of VC-B20KA/VC-B20KV and /VC-B50KA/VC-B50KV are chosen and
what can be used irrespective of the selection state of an input port. Refer to Chapter 7 “Remote
controllable item list”.
In regard to the commands that depend on the status of selection of the input ports, it is effective only
when the input port which specified "Effective inputs" in the text, is selected.
The input port written in the text: as shown in the following.
Mark in text Explanation
ANALOG Analog input of the main unit
DIGITAL Digital input of the main unit
S.ANALOG Analog input of the optional board(VC-B20KA / VC-B50KA)
S.DIGITAL Digital input of the optional board(VC-B20KA / VC-B50KA)
COMPOSITE Composite input of the optional board(VC-B20KV / VC-B50KV)
Y/C Y/C input of the optional board(VC-B20KV / VC-B50KV)
Note:
“¥r” is carriage return code (0Dh).
“_” is space code (20h)