System information

REV 4.0.
74
9. Revision archive
Description Revision date
Issue first edition (REV 1.0) July 01, 2003
Add the models, VS-XL20U / VS-50XLW20U / VS-XLW20U / VS-67XL20U
Chapter 3.1.8. Add ST Command
Chapter 3.1.9. Add the description of the lamp changer model to System
command
Chapter 3.1.11. Add PLampChange command
Chapter 4.1.15. Add OSD warning indication to SautoDisp command
Chapter 4.1.20. Add SCmode command
Chapter 4.1.38. Add Slmode command
Chapter 4.2.29. Add Ivcr command
Add the Chapter 8, Terminal functions
September 22, 2003
(Rev 1.1)
Add the model, VS-50XLF20U.
In chapter 2.3, the range of Unit ID was from 0 to 32.
In chapter 3.1.9, delete the response parameter info2 in the case of
“Para=18,19”.
Chapter 4.1.2. Add Pmech command.
Chapter 4.1.3. Add Pmechst command.
Chapter 4.1.28. Add SetFilter command.
Chapter 4.1.31. Add Sfilter command.
In chapter 4.2.20, the range of H.SIZE was “640 – 1920”.
In chapter 4.2.31, the range of V.SIZE was “8 – 1200”.
In chapter 8.3, delete “When writing the firmware, set OFF” in the Function
of dipswitch No.2.
January 14, 2004
(Rev 1.2)
Add PH series models
Chapter 4.1.19. Add Scablelength command.
Chapter 4.1.22 . Add Sdirection command.
Chapter 4.1.34 . Add SHotEx command
Chapter 4.1.40 . Add Sresol command
September 15,2005
(REV 2.0)
Add XL50 series models
Add Chapter 1 (Product list)
In chapter 3.1.8. Correct wrong description (Old:
00:Stand-by state (BLOWOUT)
01:Normal state
).
In chapter 4.1.14. Add description “When Mode of Isig command is not set
to 0, this command is not available.”
In chapter 4.2.2. Add description ” When Mode of Isig command is not set
to 0, this command is not available.”
In chapter 4.2.34, the range of horizontal crop size was “1 – 1920”.
November 15, 2005
(REV 4.0)