System information

REV 4.0.
42
4.2.2. Aswhite (Auto White )
Function: Automatic white level adjusting of analog RGB signal in selected input port. The
execution result is saved in input memory by Reginp command execution. Full-bit white
signal is required to input from the selected analog input port when this command is
executed. When Mode of Isig command is not set to 0, this command is not available. It may
take more than 700 msec till the display returns the result string after receiving a command.
Effective inputs: ANALOG, S.ANALOG
Format: ID Aswhite
Response: ID Aswhite [ _ err ]
Results status
Omitted Normal end (automatic adjusting is finished)
?00 Invalid parameter
err
?01 Execution failure
4.2.3. Deldisp (Delete Display memory)
Function: Display memory deleting. It may take more than 700 msec till the display returns the
result string after receiving a command.
Format: ID Deldisp _ MemNo
Display memory number to be deleted
MemNo
1 – 256 Display memory number
Response: ID Deldisp _ memno
Deleted display memory number
1 – 256 Display memory number
?00 Invalid parameter
memno
?01 Execution failure
4.2.4. Delinp (Delete Input Memory)
Function: Input memory deleting. It may take more than 700 msec till the display returns the result
string after receiving a command.
Format: ID Delinp _ MemNo
Input memory number to be deleted
MemNo
1 – 128 Input memory number
Response: ID Delinp _ memno
Deleted input memory number
1 – 128 Input memory number
?00 Invalid parameter
memno
?01 Execution failure