System information

REV 4.0.
30
4.1.22. Sdirection (Direction)
Function: The function: DIRECTION setting.If Cnt parameter is set 0(Cnt=0), the warning
indication to induce the filter cleaning and the temperature warning indication become invalid.
If you set to Cnt=1 by using this command, setting value of the SetFilter command is
changed to time=4000 and If you set to Cnt=0, setting value of the SetFilter command is
changed to time=0 automatically. It is preferable to reset the filter timer value by using the
Sfilter command when you set the parameter to Cnt=1.
The execution result is saved in system memory by save command execution.
Effective models: model group A, C
Format: ID Sdirection [ _ Cnt]
DIRECTION setting
0 REAR
1 FRONT
Cnt
Omitted Current setting value display
Resopnce: ID Sdirection _ cnt
Current DIRECTION setting
0 REAR
1 FRONT
?00 Invalid parameter
cnt
?01 Execution failure
4.1.23. Sdisp (Display Mode)
Function: Display mode (with/without pixel superimposition) setting. The pending commands are
updated when this command is executed. The execution result is saved in system memory
by save command execution. This command is an exclusive command for the input boards
Effective inputs: S.ANALOG, S.DIGITAL, COMPOSITE, Y/C
Format: ID Sdisp [ _ Sel ]
Display mode (with/without pixel superimposition) setting
0 Without pixel superimposition
1 With pixel superimposition
Sel
Omitted Current setting value display
Resopnce: ID Sdisp _ sel
Current display mode (with/without pixel superimposition) setting
0 Without pixel superimposition
1 With pixel superimposition
?00 Invalid parameter
sel
?01 Execution failure