System information

REV 4.0.
20
Response:ID Pmech _ motor [ _ time ]
Motor number
0 H-POSITION
1 V-POSITION
2H-KEYSTONE
3V-KEYSTONE
4TILT
5ZOOM
?00 Invalid parameter
motor
?01 Execution failure
Remaining time
1 – 127 Operation time. 1 unit time is 30ms.
0Stop
-1 –
-128
Operation time. 1 unit time is 30ms.
time
Omitted When “motor” parameter is ” ?00 ” or ” ?01 ” , “time”
parameter is omitted.
4.1.3. Pmechst (Mech Adjuster Status)
Function: To get status of Motorized Adjustment Tool. This command is valid only when Motorized
Adjustment Tool is attached. In model group C, this command is available from firmware
version “P01.70A”.
Format: ID Pmechst _ Infotype
Get current status
0 Status of Motorized Adjustment Tool
1 Model name information
Infotype
2F/W Version
Response: ID Pmechst _ infotype [ _ info ]
Current status
0 Status of Motorized Adjustment Tool
1 Model name information
2F/W Version
?00 Invalid parameter
infotype
?01 Execution failure
To describe 16 bits status as ASCII (HEX) characters.
Infotype =0
Bits Description
15
Connecting status of Motorized Adjustment Tool.
0:Connected Motorized Adjustment Tool.
1: Unconnected Motorized Adjustment Tool.
14 reserved
13
0-6, 8-13:
Indication of the end of adjustment range:
The direction to zoom out
12 The direction to zoom in
ZOOM
11 Counterclockwise direction
10 Clockwise direction
TILT
9 The direction that lower side is expanded
8 The direction that upper side is expanded
V-KEYSTONE
7 Over current is detected.
6Reserved
5 The direction that left side is expanded
4 The direction that right side is expanded
H- KEYSTONE
3 Downward
2 Upward
V-POSITION
info
0x0000~
0xffff
1Leftward H-POSITION