System information

REV 4.0.
14
3.1.7. Ovmpos (V multi position)
Function: To set vertical expansion ratio of input signal of the input boards (VC-B20KA / VC-
B20KV / VC-B50KA / VC-B50KV). It executes after UP command receiving. This command
is effective only when the Power State is “Power on state”. The execution result is saved in
display memory by Regdisp command execution.
Effective inputs: S.ANALOG､S.DIGITAL､COMPOSITE､Y/C
Format: ID Ovmpos [ _ Pos _ Num ]
Vertical screen position
1 – 32 Vertical screen position in expanded image (Top end screen is 1).
Pos
Omitted Current status display if both Pos and Num are omitted.
Vertical screen numbers
1 – 32 Vertical screen numbers
Num
Omitted Current status display if both Pos and Num are omitted.
Response: ID Ovmpos _ pos [ _ num ]
Current status display after command executing
1 – 32 Vertical screen position in expanded image
?00 Invalid parameter
pos
?01 Execution failure
Current status display after command executing
1 – 32 Vertical screen numbers
num
Omitted It is omitted when pos is ”?00” or ”?01”.