System information

13
3.1.5. Callinp (Input Memory Call)
Function: To call input memory. It executes after UP command receiving. Input port is allocated
ANALOG､DIGITAL､S.ANALOG､S.DIGITAL､COMPOSITE or Y/C according to the selected
input memory. This command is effective only when the Power State is “Power on state”.
Status is automatically saved at shut down
Format: ID Callinp [ _ Mem ]
Input memory number
1 – 128 Input memory number designation
Mem
Omitted Current status display
Response: ID Callinp _ mem
Current input memory number
0 Memory is not called
1 – 128 Memory number designation
?00 Invalid parameter
mem
?01 Execution failure
3.1.6. Ohmpos (H multi position)
Function: To set horizontal expansion ratio of input signal of the input boards (VC-B20KA / VC-
B20KV / VC-B50KA / VC-B50KV). It executes after UP command receiving. This command
is effective only when the Power State is “Power on state”. The execution result is saved in
display memory by Regdisp command execution.
Effective inputs: S.ANALOG､S.DIGITAL､COMPOSITE､Y/C
Format: ID Ohmpos [ _ Pos _ Num ]
Horizontal screen position
1 – 32 Horizontal screen position in expanded image (Left end screen is 1).
Pos
Omitted Current status display if both Pos and Num are omitted.
Horizontal screen numbers
1 – 32 Horizontal screen numbers
Num
Omitted Current status display if both Pos and Num are omitted.
Response: ID Ohmpos _ pos [ _ num ]
Current status display after command executing
1 – 32 Horizontal screen position in expanded image
?00 Invalid parameter
pos
?01 Execution failure
Current status display after command executing
1 – 32 Horizontal screen numbers
num
Omitted It is omitted when pos is ”?00” or ”?01”.