System information

REV 4.0.
12
3.1.2. UP (Update)
Function: To execute update. It may take more than 700 msec till the display returns the result
string after receiving a command. This command is effective only when the Power State is
“Power on state”.
Format: ID UP
Response: ID UP [ _ err ]
Response parameter
(non) Updated
?00 Invalid parameter
err
?01 Execution failure
3.1.3. Pmute (Mute)
Function: To control picture mute. It executes after UP command receiving. This command can be
accepted during stand-by state. In this case, issuing [ vP _ 1 ] command executes UP
command automatically after start-up process. If the mute command is issued during stand-
by state, UP command is not required. The status is reset and the mute is canceled by
executing [ vP _ 0 ] command or by turning off with main power switch.
Format: ID Pmute [ _ Mute ]
Picture mute on/off control
0 Picture mute cancel
1 Picture mute
Mute
Omitted Current status display
Response: ID Pmute _ mute
Current status display (except mute status due to no signal)
0 Picture mute cancel
1 Picture mute status
?00 Invalid parameter
mute
?01 Execution failure
3.1.4. Calldisp (Display Memory Call)
Function: To call display memory. It executes after UP command receiving. Status is automatically
saved at shut down. This command is effective only when the Power State is “Power on
state”.
Format: ID Calldisp [ _ Mem ]
Display memory number
1 – 256 Memory number designation
Mem
Omitted Current status display
Response: ID Calldisp _ mem
Current display memory number
0 Memory is not called
1 – 256 Memory number designation
?00 Invalid parameter
mem
?01 Execution failure