Operating instructions

Using other functions
08
72
En
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to OFF.
• Disconnect the iPod and USB memory device from
the receiver beforehand.
1 Switch the receiver into standby.
2 While holding down
ENTER on the front panel,
press
 STANDBY/ON .
The display shows RESET  NO .
3 Select ‘ RESET ’ using PRESET +/– , then press ENTER
on the front panel.
The display shows RESET? OK.
4 Press ENTER to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
Default system settings
Setting Default
Digital Video Conversion ON
SPEAKERS A
Surround Back System Normal
Speaker System Front SMALL
Center SMALL
Surr SMALL
SB SMALLx2
SW YES
Crossover 80 Hz
X-Curve OFF
THX Audio Setting 4 ft<
DIMMER Brightest
Inputs
See Input function default and possible settings on page 44.
MULTI-ZONE
ZONE 2/ZONE 3 (VSX-23TXH only) Volume
Level
Variable
ZONE 2/ZONE 3 (VSX-23TXH only) Volume –60 dB
HDMI
HDMI Audio Amp
HDMI output (VSX-23TXH only) HDMI OUT ALL
KURO LINK ON
DSP
Surround back channel Processing ON
Phase Control ON
Sound Retriever
iPod/USB function
ON
Other functions
OFF
Sound Delay 0.0 frame
Dual Mono CH1
DRC AUTO
SACD Gain 0 dB
LFE Attenuate 0 dB
Auto delay OFF
Up Mix ON
Digital Safety OFF
Effect Level EXT.STEREO 90
Other modes 50
2 PL II Music
Options
Center Width 3
Dimension 0
Panorama OFF
Neo:6 Options Center Image Neo:6 MUSIC: 3
Neo:6 CINEMA: 10
All Inputs Listening Mode
(2 ch)
AUTO
SURROUND
Listening Mode
(x ch)
AUTO
SURROUND
Listening Mode (HP) STEREO
See also Setting the Audio options on page 66 for other default
DSP settings.
MCACC
MCACC Position Memory M1: MEMORY 1
Channel Level (M1 to M6) 0.0 dB
Speaker Distance (M1 to M6) 10’00”
Standing Wave
(M1 to M6)
ATT of all channels/
filters
0.0 dB
SWch Trim 0.0 dB
EQ Data (M1 to M6) All channels/bands 0.0 dB
EQ Trim 0.0 dB
Setting Default
VSX-23TXH_CUXJ.book 72 ページ ２００９年５月８日 金曜日 午前１０時４５分