Specifications

2 - 1
2
CHAPTER 2 EXERCISE ITEMS, PARAMETERS, AND SETUP AND PROCEDURES
BEFORE STARTING THE OPERATION
2.1 Exercise Items
Exercise items are shown below.
Item Check item
Common parameter Check that the data link can be executed by setting the
parameter with peripheral devices.
Assignment I
(Cyclic transmission)
Monitoring/testing of
peripheral devices
Check the data link status by monitoring/testing peripheral
devices.
Dedicated link instruction Check that the transient transmission can be executed by the
SEND/RECV instruction.
Access operation to the
other station
Check that the same function as that used when accessing to
the host station can also be used when accessing to the other
station.
Assignment II
(Transient transmission)
Direct access Check that the link devices (B, W, X, Y, SB, SW) of the network
module can be directly read or written.
Assignment III
(Remote I/O network)
Parameter of the remote
master station
Configure the remote I/O network and check that the data link
can be executed between the remote I/O station and the remote
master station and with each station of the PLC to PLC network.
Assignment IV
(Routing function)
Routing parameter Check that accessing the PLC on the other network via multiple
networks is enabled.