User`s manual

9 - 2 9 - 2

MELSEC-Q

9 SPRING CLAMP TERMINAL BLOCK

(b) Installation of Q6TE-18S

Mount Q6TE-18S onto the module and tighten the terminal block mounting

screws within the specified torque range.

Q6TE-18S

Terminal block

mounting screw

Module

Insert the tool into the square shaped hole, which corresponds to the

terminal you wish to use.

While the tool is inside the hole, insert the wire into the circular shaped hole

(as shown below).

Remove the tool from the square shaped hole, taking care not to remove

the wire.

After the wire has been clamped, gently pull the wire to confirm that it is

secure.

Square shaped hole

Circular shaped hole

Wire strip length:

8mm to 11mm *

Wire

Tool

[Cautions]

* Take care that the wire strip length is between 8mm to 11mm.

If the wire strip length is too long, this will expose the bare wire, which increases the risk of

electric shock or short circuit.

If the wire strip length is too short, this will result in the wire not being securely attached.

(d) Cable removal

Insert the tool into the corresponding square shaped hall until it stops.

Pull the wire out of the hall completely.