User`s manual

9 - 1 9 - 1

MELSEC-Q

9 SPRING CLAMP TERMINAL BLOCK

9. SPRING CLAMP TERMINAL BLOCK

9.1 Q6TE-18S

The Q6TE-18S shall be used attached to a Q Series terminal block type I/O module or

an intelligent function module.

Since the Q6TE-18S uses a spring clamp it does not require screw tightening, which

greatly reduces the number of wiring procedures.

(1) Compatible Models

The QT6E-18S can be used with the following models:

Model type Model name

QX10 QX28 QX40 QX40-S1 QX50 QX70

QX80 QY10 QY18A QY22 QY40P QY50

I/O module

QY68A QY70 QY80 QX48Y57 QI60

Q62DA Q64DA Q68DAV Q68DAI

Q64AD Q68ADV Q68ADI

Intelligent function

module

Q64TCRT Q64TCRTBW Q64RD

POINT

The terminal numbers of the Q6TE-18S correspond to the terminal numbers on the

compatible module.

For the signal names corresponding to the terminal numbers when connected to an

external device, please refer to the User's Manual of the module to use.

(2) Specifications

Q6TE-18S specification is explained.

Item Specifications

Applicable wire size

0.3 to 1.5 mm

(AWG22 to 16)

Wire strip length 8 to 11 mm

Mounting screw tightening torque range 66 to 89 Nycm

Weight 0.07kg

(3) Removal of Terminal Block and Installation of Q6TE-18S

(a) Removal of terminal block

Unscrew the two terminal block mounting screws situated at the top and

bottom of the terminal block and take them off.

Terminal block

Terminal

block mounting

screw

Module