Instruction manual

English-21
English
Signal cable
(mini D-SUB 15-pin – mini D-SUB 15-pin)
To audio output
D-SUB/YPbPr IN
AUDIO
ANALOG IN
Audio cable
(ø3.5-mm stereo mini)
To D-SUB output
LCD monitor (rear)
LCD monitor
(side)
Personal computer
(Analog RGB)
Connecting with a computer (analog connection)
Analog connection:
(1) Connect a signal cable (mini D-SUB 15-pin – mini D-SUB 15-pin) (accessory) to the D-SUB/YPbPr IN connector.
(2) Select [D-SUB] using the INPUT button on the monitor or the D-SUB button on the wireless remote control. At the moment of
the selection, the audio is automatically switched to [ANALOG].
Audio connection:
• Connect an audio cable (ø3.5-mm stereo mini) (commercially available) to the AUDIO ANALOG IN connector.
Because the audio is automatically switched to [ANALOG] when [D-SUB] is selected, the audio is output just by connecting the
cable.
P-4 Connection procedure (continued)
The monitor automatically distinguishes the timings shown in the table below and sets the screen information. When a PC or other
device is connected, it automatically displays images properly. See the page describing AUTO SETUP/AUTO ADJUST.
<Factory preset timing>
Resolution
Frequency
Remarks Resolution
Frequency
Remarks
Horizontal Vertical Horizontal Vertical
1 640 x 480 31.5 kHz 60 Hz 9 1280 x 1024 64.0 kHz 60 Hz
2 800 x 600 37.9 kHz 60 Hz 10 1400 x 1050 65.3 kHz 60 Hz
3 1024 x 768 48.4 kHz 60 Hz 11 1680 x 1050 64.7 kHz 60 Hz
4 1280 x 720 45.0 kHz 60 Hz 12 1600 x 1200 75.0 kHz 60 Hz
5 1280 x 768 47.8 kHz 60 Hz 13 1920 x 1080 56.2 kHz 50 Hz
6 1280 x 800 49.7 kHz 60 Hz 14 1920 x 1080 67.5 kHz 60 Hz Recommend timing
7 1360 x 768 47.7 kHz 60 Hz 15 1920 x 1200 74.0 kHz 60 Hz
CVT Reduced Blanking
8 1440 x 900 55.9 kHz 60 Hz
NOTE:
When a signal other than 1920 x 1080 is input, characters may be blurred and fi gures and objects may be distorted.
Images may not be displayed correctly depending on the video card or driver being used.