Technical information

56
MITSUBISHI ELECTRIC
MICRO CONTROLLERS
/// MICRO CONTROLLERS
Network Module for Ethernet
The FX3U-ENE T communications modules pro
-
vides the FX3U or FX3UC PLC with a direct con
-
nectionontoanEthernetnetwork.
With the Ethernet module installed an PLC can
exchange data quickly and easily with process
visualization systems in addition to supporting
full program UP/DOWN load as well as compre
-
hensive monitoring support.
The FX3U-ENE T also support Peer to Peer con
-
nection and MC Protocol. I t is easily set-up with
the FX Configurator-EN software.
POWER
RUN
C1
INIT.
C2
100M
C3
SD
C4
RD
C5
ERR.
C6
COM.ERR.
C7
C8
10BASE-T/100BASE-TX
FX3U-ENET
Specifications FX3U-ENET
Protocol TCP/IP, UDP
Communication mode Full-duplex / half-duplex
No. of simultaneous open connections 8
Fixed buffer communication 1023 wordx 8
Communication with mailserver SMTP, POP3
Interface IEEE802.3u (100BaseTX), IEEE802.3 (10BaseT)
Connector RJ45
Max. transfer rate 100 Mbits/s, 10 Mbit/s
Max. segment length m 100
Cable CAT5STPor3STP
Power supply 24 V DC / 240 mA (from base unit)
Related I/O points 8
Dimensions(WxHxD) mm 55x90x87
Order information
Art. no. 166086
Specifications FX2NC-ENET-ADP
Protocol TCP/IP
No. of simultaneous open con-
nections
1
Interface IEEE802.3u (100BaseTX), IEEE802.3 (10BaseT)
Connector RJ45 (to Ethernet), 3 screwterminals (to ground)
Max. transfer rate 10 Mbit/s
Cable CAT5STPor3STP
Power supply
5 V DC 135 mA(from baseunit)
24 V DC —
Related I/O points 0
Dimensions(WxHxD) mm 19.1x90x78
Order information
Art. no. 157447
Note: When connecting this adapter module to a FX1Sor FX1NPLC the communications adapter FX1N-CNV-BDis require d.When connectingthis adaptermod-
ule to a FX2N PLC the communications adapterFX2N-CNV-BD is required.
Ethernet Communications Adapter FX2NC-ENET-ADP
The FX2NC-ENE T-ADP communications adapter
is an Ethernet interface with 10BASE-T specifi-
cations for the FX1S, FX1N and FX2N series.
The FX2NC-ENET-ADP enables upload, down-
load, monitor and test sequence of programs
via Ethernet from a pers onal computer (the
softwareGXDeveloperorMXComponents
must be installed).
POWER
LINK
ACT
FX -ENET-ADP
2NC
SD
RD
Automation Book_UK_2008.prn
Automation Book_UK_2008
Dienstag, 8. April 2008 18:20:55
Farbprofil: Deaktiviert
Komposit Standardbildschirm