Instruction manual

4. SERVO SYSTEM CPU DEVICES
4 − 35
(3) Manual pulse generator 1-pulse input magnification setting registers
(D720 to D751)............................................................ Data from SCPU to PCPU
(a) This register is used to set the magnification (1 to 100) per pulse of the input
pulse count from the manual pulse generator for manual pulse generator
operation.
1-Pulse Input
Magnification
Setting Register
Correspondin
g Axis No.
Setting
Range
1-Pulse Input
Magnification
Setting Register
Correspondi
ng Axis No.
Setting
Range
D720 Axis 1 D736 Axis 17
D721 Axis 2 D737 Axis 18
D722 Axis 3 D738 Axis 19
D723 Axis 4 D739 Axis 20
D724 Axis 5 D740 Axis 21
D725 Axis 6 D741 Axis 22
D726 Axis 7 D742 Axis 23
D727 Axis 8 D743 Axis 24
D728 Axis 9 D744 Axis 25
D729 Axis 10 D745 Axis 26
D730 Axis 11 D746 Axis 27
D731 Axis 12 D747 Axis 28
D732 Axis 13 D748 Axis 29
D733 Axis 14 D749 Axis 30
D734 Axis 15 D750 Axis 31
D735 Axis 16
1 to 100
D751 Axis 32
1 to 100
(b) Refer to Section 7.20 of the Motion Controller (SV13/SV22 REAL Mode)
programming manual (type A273UH/A173UH) for details of manual pulse
generator operation.