Instruction manual

2. PROCEDURE FOR VIRTUAL MODE POSITIONING CONTROL
2 − 1
2. PROCEDURE FOR VIRTUAL MODE POSITIONING CONTROL
The procedure for VIRTUAL mode positioning control is discussed in this section.
2.1 System Start-Up
The procedure for a VIRTUAL mode system start-up is shown below.
Start SW0IX-CAMPE
Write setting data to hard disk
or floppy disk, then end
SW2SRX-GSV22PE operation
Register SW2SRX-GSV22PE,
SW0SRX-CAMPE
Start SW2SRX-GSV22PE
Designate system settings
Designate the following
positioning parameter settings:
•
Fixed parameters
•
Servo parameters
•
Parameter block
Conduct a relative check and
correct setting errors
Will cam be used?
START
NO
YES
Section 2.3
(1)
(11)
Reference Section Reference Manual
Motion Controller
(SV13/22 REAL Mode)
Programming Manual
(type A273UH/A173UH)
SW2SRX-GSV22PE,
SW0IX-CAMPE
Operating Manual
Chapter 4
Section 6.1
Chapter 7
Chapter 8
Section 8.4
Section 6.2
Section 21.1
Chapter 4
Chapter 4
Setting by
peripheral
device