Instruction manual

8. OUTPUT MODULES
8 − 40
(e) Cam data
• Set the cam data (max. 4 blocks).
The order of storing the cam data need not be in the order of the cam
Nos.
• Set each cam data as the stroke ratio (integer) of 0 to 7FFF
H
(32767).
Also, the cam data requires "0" and "7FFF
H
(32767)" points.
In the beginning of the cam data, store the control mode, cam No.,
resolution, and stroke/cam No. change position. (Refer to Section 8.4.2)
1) First block
R72
R73
R74
R75
R76
b15 b8 b7 b0
Dummy (no need to set)
Control mode Cam No.
Resolution
Stroke/cam No. change position
Sumcheck
Set stroke ratio (0 to 7FFF )
from 0 on (resolution - 1).
Control mode
Cam No.
Set 1 to 64 (1 to 40 ).
0: Reciprocating cam, 1: Feed cam
Set 256, 512, 1024, 2048.
Set value from 0 on (resolution - 1).
to
H
H
2) Second block
R1580
R1581
R1582
R1583
R1584
b15 b8 b7 b0
to
Dummy (no need to set)
Control mode Cam No.
Resolution
Stroke/cam No. change position
Sumcheck
Set stroke ratio (0 to 7FFF )
from 0 on (resolution - 1).
Control mode
Cam No.
Set 1 to 64 (1 to 40 ).
0: Reciprocating cam, 1: Feed cam
Set 256, 512, 1024, 2048.
Set value from 0 on (resolution - 1).
H
H
3) Third block
R1920
R1921
R1922
R1923
R1924
b15 b8 b7 b0
Dummy (no need to set)
Control mode
Cam No.
Resolution
Stroke/cam No. change position
Sumcheck
Set stroke ratio (0 to 7FFF )
from 0 on (resolution - 1).
Control mode Cam No.
Set 1 to 64 (1 to 40 ).
0: Reciprocating cam, 1: Feed cam
Set 256, 512, 1024, 2048.
Set value from 0 on (resolution - 1).
to
H
H
4) Fourth block
R2249
R2250
R2251
R2252
R2253
b15
b8 b7
b0
to
Dummy (no need to set)
Control mode Cam No.
Resolution
Stroke/cam No. change position
Sumcheck
Set stroke ratio (0 to 7FFF )
from 0 on (resolution - 1).
Control mode Cam No.
Set 1 to 64 (1 to 40 ).
0: Reciprocating cam, 1: Feed cam
Set 256, 512, 1024, 2048.
Set value from 0 on (resolution - 1).
H
H
REMARKS
As the memory cassette, the A3NMCA16 (128k bytes) or more is required.