Instruction manual

7. TRANSMISSION MODULE
7 − 25
(2) Mode setting device (set only when using ON/OFF mode, address mode,
address mode 2 and one-shot mode in conjunction; 1 word)
(a) This is the device used to switch between the ON/OFF mode and the
address mode.
The settings of the mode setting device are as follows:
• 0 : ON/OFF mode
• 1 : Address mode
• 2 : Address mode 2
• 3,4 : One-shot mode
If a value other than 0 or 4 is set, this is regarded as an error and the
previously set mode remains in effect.
(b) The following devices can be used as the mode setting device.
Data register
(Note-1)
D800 to D3069
(Note-2)
D3080 to D8191
Link register W0 to W1FFF
(Note-1) : If a cam is used at the output module, the area used for the cam cannot
be set.
(Note-2) : D800 to D1559 are devices dedicated to the virtual servo motor axes,
synchronous encoder axes and output module "cams" in the virtual
mode. The areas of the unused virtual servo motor, synchronous encoder
and cam axes are available for the user.
(3) Clutch ON/OFF command device
(a) This device is used to execute the clutch ON/OFF command.
(b) The following devices can be used as the clutch ON/OFF command device.
Input X0 to X1FFF
Output Y0 to Y1FFF
Internal relay/
latch relay
M/L0 to M/L8191
Special relay M9000 to M9255
TC0 to TC2047 (timer coil)
Timer
TT0 to TT2047 (timer contact)
CC0 to CC1023 (counter coil)
Counter
CT0 to CT1023 (counter contact)
Link relay B0 to B1FFF
Annunciator F0 to F2047