Instruction manual

7. TRANSMISSION MODULE
7 − 15
(4) One-shot mode
(a) Control switches to that of the one-shot mode as soon as the "mode setting
device value" changes to "3: One-shot mode clutch ON command enable"
or "4: One-shot mode clutch ON command disable".
(b) While the "mode setting device value" is "3", the clutch ON/OFF command
device is valid, and the following control is exercised according to the clutch
ON/OFF command device on the basis of the specified after-clutch ON
travel value set in the "clutch ON address setting device" and the specified
before-clutch ON travel value set in the "clutch OFF address setting device".
1) When the clutch ON/OFF command device turns from OFF to ON
When the clutch ON/OFF command device turns from OFF to ON, the
clutch turns ON after movement of the travel value set as the specified
before-clutch ON travel value, and the clutch is turned OFF after
transmission of the travel value set as the specified after-clutch ON travel
value.
2) When the clutch ON/OFF command device turns from ON to OFF
If the clutch ON/OFF command device turns from ON to OFF, it has no
influence on the clutch processing. The clutch status is held as-is.
3
1)
2)
Mode setting device value
Drive module current value
Clutch ON command
d
evice
C
lutch status
C
lutch status device
1) Specified after-clutch ON travel value, 2) Specified before-clutch ON travel value