Instruction manual

7. TRANSMISSION MODULE
7 − 13
(3) Address mode 2
Control switches to that of the address mode 2 as soon as the "mode setting
device" value changes to "2: Address mode 2".
(a) While the "clutch ON/OFF command device" is ON, the following control is
exercised according to the current clutch status.
1) When the current clutch status is OFF
When the address set in the "clutch ON address setting device" is
reached, the clutch turns ON. After that, the status in 2) is established.
2) When the current clutch status is ON
When the address set in the "clutch OFF address setting device" is
reached, the clutch turns OFF. After that, the status in 1) is established.
(b) While the "clutch ON/OFF command device" is OFF, the clutch is OFF and
the above control is not exercised. The above control is resumed by turning
ON the "clutch ON/OFF command device".
2
1)
2)
Clutch OFF address is monitored for control.
Clutch ON address is monitored for control.
1)
2)
1)
2)
1) 1)
Mode setting device value
Clutch ON/OFF command
device
Drive module current value
Clutch status
Clutch status device
Clutch ON
address
Clutch ON
address
Clutch OFF
address
Clutch
OFF
address
Controlled in address mode 2
POINT
(1) The "clutch ON address setting device" and "clutch OFF address setting
device" can be rewritten any time. Note that since they have 2-word data,
always use the DMOV(P) instruction to make setting.
(2) Use this mode when the clutch ON time (clutch OFF time) is extremely
short (shorter than the sequence scan time).