Instruction manual

6. DRIVE MODULE
6 − 29
6.2.2 Parameter list
The synchronous encoder parameters are shown in Tables 6.4.
For details regarding the synchronous encoder parameter setting procedure, refer
to the SW2SRX-GSV22PE/SW0IX-CAMPE Operating Manual.
Table 6.4 Synchronous Encoder Parameter List
No. Setting Item Default Value Setting Range
1 Encoder No.

1 to 12
2 Operation mode when error occurs Continuation Continuation/Clutch OFF
(a) Encoder No.
Designates the number of the synchronous encoder which is connected to
the manual pulse generator and synchronous encoder interface.
Manual Pulse Generator/Synchronous Encoder Interface Unit’s Encoder No.
P1/E1 1
P2/E2 2
P3/E3 3
P4/E4 4
P5/E5 5
P6/E6 6
P7/E7 7
P8/E8 8
P9/E9 9
P10/E10 10
P11/E11 11
P12/E12 12
P1 to P12 : Connected to the manual pulse generator’s input interface. This
is for incremental type synchronous encoders.
E1 to E12 : Connected to the serial synchronous encoder interface. This is
for absolute type synchronous encoders.
(Note): The absolute and incremental synchronous encoders can be used
(set) together.