User`s guide

Configuration with the Configuration Tool
66 Mitsubishi Electric, MA00759F
Date/Time Format
Setting of the date and time format.
Date format:
The format can be YY-MM-DD, YYMMDD, DD.MM.YY, DD/MM/YY or
MM/DD/YY where Y=year, M=month and D=day.
Time format:
The format can be HH:MM:SS or HH:MM where H=hour, M=minute and
S=second.
Time zone (minutes):
The local time zone offset to UTC (Coordinated Universal Time) given in the format
+HH:MM or -HH:MM. The value should not include any daylight saving adjust-
ment, since this is calculated separately.
Clock used:
Terminal means that the operator panel’s built-in clock is used, and controller 1 or 2
means that the clock in controller 1 or 2 is used.
Clock→Controller 1/2:
Select if the clock in the operator panel is to be transferred to a data register in the
controller 1 or 2.
Update interval (seconds):
Indicate how often the operator panel is to transfer the clock data to the controller.
The value is given in seconds, and 60 seconds is recommended. A shorter updating
interval will make communication between the operator panel and the controller
slower.
Note:
This setting is ignored unless SNTP time sync (see below) is used.
Note:
In those cases where the controller has an activated real-time clock and the operator
panel clock is to be transferred to the same data register, the controller clock has pre-
cedence.