User`s guide

Project Transfer
302 Mitsubishi Electric, MA00759F
Parameter Description
Percent complete Shows how much of the project has been transferred during the transfer.
Byte count (kb) Shows how many kilobytes have been transferred during the transfer.
Time elapsed Shows how much time has elapsed since the functions Send, Receive or Verify
were activated.
Status Shows the transfer status and which part of the project is being transferred.
E.g. properties, individual blocks, alarm groups, individual symbols and func-
tion keys.
Info Shows the defined driver to be transferred to the operator panel.
Retries In the event of transfer problems, the configuration tool makes a number of
retries before the transfer shuts down.
Terminal Version When contact has been established with the operator panel, the current
operator panel type and its system program version number are shown.
Test project on
send
Automatically tests the project before transfer.
Automatic termi-
nal RUN/TRANS-
FER switching
The operator panel is automatically set in transfer mode and returns after
transfer to the mode the operator panel was in before the transfer.
Check terminal
version
Compares the system program version in the operator panel with the
installed version for the project in the configuration tool.
Send complete
project
Select whether the complete project is to be transferred.
Partial send
options
Block
None: No blocks to be sent to operator panel.
All: All blocks to be sent to operator panel.
From To: Specify an interval of blocks to be sent to the operator
panel.
Alarms: Select if alarms are to be sent to the operator panel.
Data Loggers: Select if data loggers ar to be sent to the operator panel.
Symbols: Select if symbols are to be sent to the operator panel.
Time channels: Select if time channels are to be sent to the operator panel.
LEDs: Select if LEDs are to be sent to the operator panel.
Macros: Select if macros are to be sent to the operator panel.
Fonts*: Select if fonts are to be sent to the operator panel.
Message library: Select if message library is to be sent to the operator panel.
Setup: Select if configurations under Properties are to be sent to
the operator panel.
Function keys: Select if function keys are to be sent to the operator panel.
Passwords: Select if passwords are to be sent to the operator panel.
Data exchange: Select if data transfer is to be sent to the operator panel.