Installation manual
Table Of Contents
- Foreword
- 1 Safety Precautions
- 2 Installation
- 2.1 Space Requirements
- 2.2 Installation Process
- 1. Unpack and check the delivery. If damage is found, notify the supplier.
- 2. Place the panel cut out where the operator terminal is to be situated, draw along the outer sides of the holes and cut according to the markings.
- 3. Secure the operator terminal in position, using all the fastening holes and the provided brackets and screws:
- 4. Connect the cables in the specified order.
- 5. Carefully remove the laminated film over the operator terminal display, to avoid static electricity that could damage the terminal.
- 2.2.1 Mode Switches
- 2.2.2 Connections to the Controller
- 2.2.3 Other Connections and Peripherals
- 3 Technical Data
- 4 Chemical Resistance
- 5 Operator Terminal Drawings
