Installation manual
Table Of Contents
- Foreword
- 1 Safety Precautions
- 2 Installation
- 2.1 Space Requirements
- 2.2 Installation Process
- 1. Unpack and check the delivery. If damage is found, notify the supplier.
- 2. Place the panel cut out where the operator terminal is to be situated, draw along the outer sides of the holes and cut according to the markings.
- 3. Secure the operator terminal in position, using all the fastening holes and the provided brackets and screws:
- 4. Connect the cables in the specified order.
- 5. Carefully remove the laminated film over the operator terminal display, to avoid static electricity that could damage the terminal.
- 2.2.1 Mode Switches
- 2.2.2 Connections to the Controller
- 2.2.3 Other Connections and Peripherals
- 3 Technical Data
- 4 Chemical Resistance
- 5 Operator Terminal Drawings
Chemical Resistance
Mitsubishi Electric, MA00779 4-1
4 Chemical Resistance
4.1 Metal Casing
The frame and casing material is powder-coated aluminum. This powder paint
withstands exposure of up to 24 hours duration to the following chemicals without
visible change:
4.2 Keyboard and Display
4.2.1 Autotex F250
Autotex F250 covers the overlay surrounding the touch screen.
Solvent Resistance
Autotex F250 withstands exposure of more than 24 hours duration under DIN 42
115 Part 2 to the following chemicals without visible change:
Ammonia 25% Isopropyl alcohol Nitric acid 3%
De-ionized water Tap water Chlorhydric acid 10%
Butanol Cooling liquid 50% Washer fluid 33%
Citric acid 10% Ligroin Sulphuric acid 20%
Diesel Cooking oil Turpentine
Ethanol 99.5% denaturated Lactic acid 10% Urea saturated
FAM-Normal petrol Sodium di-chromate
saturated
Hydroperoxide 3%
Alcohol 95% Caustic soda 5% Acetic acid 10%
Phosphoric acid 43% Sodium hypochlorite
solution
Alu-cleaner
Glycol Sodium carbonate 10% -
Industrial petrol Sodium chloride 20% -
Potassium ferrocyanide/
ferricyanide
Sodium hypchlorite <20%
(bleach)
1.1.1. Trichloroethane
(Genklene)
Cyclohexanol Acetaldehyde Ethylacetate
Diacetone alcohol Aliphatic hydrocarbons Diethyl ether
Glycol Toluene N-Butyl acetate
Isopropanol Xylene Amylacetate
Glycerine White spirit Butycellosolve
Methanol Fromic acid <50% Ether
Triacetin Acetic acid <50% MIBK
Dowanol DRM/PM Phosphoric acid <30% Cutting oil
Acetone Hydrochloric acid <36% Potassium carbonate
Metyl ethyl ketone Nitric acid <10% Washing powders
Dioxan Trichloracetic acid <50% Fabric conditioner
Cyclohexanone Sulphuric acid <10% Ferric chloride
Ethanol Formaldehyde 37% - 42% Ferrous chlorid
Isophorone Potassium hydroxide <30% Dibutyl Phthalate