Installation manual
Table Of Contents
- Foreword
- 1 Safety Precautions
- 2 Installation
- 2.1 Space Requirements
- 2.2 Installation Process
- 1. Unpack and check the delivery. If damage is found, notify the supplier.
- 2. Place the panel cut out where the operator terminal is to be situated, draw along the outer sides of the holes and cut according to the markings.
- 3. Secure the operator terminal in position, using all the fastening holes and the provided brackets and screws:
- 4. Connect the cables in the specified order.
- 5. Carefully remove the laminated film over the operator terminal display, to avoid static electricity that could damage the terminal.
- 2.2.1 Mode Switches
- 2.2.2 Connections to the Controller
- 2.2.3 Other Connections and Peripherals
- 3 Technical Data
- 4 Chemical Resistance
- 5 Operator Terminal Drawings
Technical Data
Mitsubishi Electric, MA00779 3-1
3 Technical Data
Parameter E1101
Front panel, W x H x D 302 x 228 x 6 mm
Mounting depth 58 mm (158 mm including clearance)
Front panel seal IP 66
Rear panel seal IP 20
Keyboard material/
Front panel
Touch screen: Polyester on glass *, 1 million finger touch
operations.
Overlay: Autotex F250 *.
Reverse side material Powder-coated aluminum
Weight 2.0 kg
Serial port RS422/
RS485
25-pin D-sub contact, chassis-mounted female with
standard locking screws 4-40 UNC.
Serial port RS232C 9-pin D-sub contact, male with standard locking screws 4-40
UNC.
Ethernet Shielded RJ 45
USB Host type A, power consumption max. 500mA
Device type B
CF-slot Compact flash, type I and II
Flash memory for
application
4 MB
Real time clock ±20 PPM + error because of ambient temperature and supply
voltage.
Total max error: 1 min/month at 25 °C
Minimum life of the real time clock battery: 3 years
Temperature coefficient: 0.004 ppm/°C
2
Power consumption at
rated voltage
Normal: 0.5 A
Maximum: 1.0 A
Display TFT-LCD. 800 x 600 pixels, 64K color.
CCFL backlight lifetime at the ambient temperature of
+25 °C: 50,000 h.
Active area of display,
W x H
211.2 x 158.4 mm
Fuse Internal DC fuse, 3.15 AT, 5 x 20 mm
Power supply +24V DC (20 - 30V DC). 3-pin jack connection block.
CE: The power supply must conform with the requirements
for SELV or PELV according to IEC 950 or IEC 742.
UL: The power supply must conform with the requirements
for class II power supplies.
Ambient temperature Vertical installation: 0 ° to +50 °C
Horizontal installation: 0 ° to +40 °C
Storage temperature -20 ° to +70 °C
Relative humidity 5 - 85 % non-condensed
EMC tests on the
operator terminal
The operator terminal conforms with the essential protection
requirements in article 4 of the directive 89/336/EEC. Noise
tested according to EN6100-6-4 emission and EN61000-6-2
immunity.
UL, cUL approvals Certification in progress
* See section Chemical Resistance for keyboard and display