Installation manual
Table Of Contents
- Foreword
- 1 Safety Precautions
- 2 Installation
- 2.1 Space Requirements
- 2.2 Installation Process
- 1. Unpack and check the delivery. If damage is found, notify the supplier.
- 2. Place the panel cut out where the operator terminal is to be situated, draw along the outer sides of the holes and cut according to the markings.
- 3. Secure the operator terminal in position, using all the fastening holes and the provided brackets and screws:
- 4. Connect the cables in the specified order.
- 5. Carefully remove the laminated film over the operator terminal display, to avoid static electricity that could damage the terminal.
- 2.2.1 Mode Switches
- 2.2.2 Connections to the Controller
- 2.2.3 Other Connections and Peripherals
- 3 Technical Data
- 4 Chemical Resistance
- 5 Operator Terminal Drawings
Installation
Mitsubishi Electric, MA00779 2-3
2.2.1 Mode Switches
All mode switches must be in OFF position during operator terminal use.
The mode switches should not be touched unless by qualified personell.
2.2.2 Connections to the Controller
For information about the cables to be used when connecting the operator terminal
to the controller, please refer to the help file for the driver in question.
2.2.3 Other Connections and Peripherals
Cables, peripheral equipment and accessories must be suitable for the application
and its environment. For further details or recommendations, please refer to the
supplier.
Caution
When using a compact flash card, do not remove the card when the busy indicator is
illuminated.
1
24V DC
CF CARD
COM 1
RS422
RS485
COM 2
RS232
10/100
EXPANSION
BUSY
MODE
1234
ON DIP
MODE
1234
ON DIP