Specifications

7 - 14
7.3.2 Sequence program
Create a sequence program.
Establish a connection with Active open of the PLC CPUs on the A1 to A5 side, and
then send and receive data.
POINT
(1) When communicating without procedures, note that the specification of data
length is in byte units.
When communicating with procedures, it is in word units.
(2) After creating a sequence program, perform the following operations with the
GX Developer.
1) Saving to FD
Drive/Path name: A:
\
Q-E71
Project name: EX3- B
( indicates demonstration machine No.)
Example: For the demonstration machine No.1, EX3-B1
2) Designating the connection destination (Refer to Section 5.2.3)
3) Writing to the PLC CPU (Refer to Section 5.2.4)