Specifications

5 - 36
Continued from the previous page
9) Check the written numerical value in the MX
Component.
(*1)
Refer to Section 5.4.2 (3), start up "PLC Monitor
Utility" and set the logical station number to "1".
Click [Start]
[All Programs] [MELSOFT
Application]
[MX Component] [PLC Monitor
Utility].
In the Transfer setting screen, set "Logical station
number" to "1" and click the OK
button.
10) Input "D0" in "Device", then click the
Start monitor
button.
11) Check that the written device value appears.
Then click the Exit
button.
Continued to the next page
12) Click the Close
button to close the
communication line.
When closing normally, "Communication line was
closed normally." appears in Communication
status.
The error code appears at abnormal.
For details of error codes, refer to Appendix 2.3.