User`s manual

(36/46)

FL: Option

bit 0: Everyday

bit 1: Every week

bit 2: Schedule Disable/Enable

* When bit0 and bit1 are '1', it behaves as Everyday.

EX.

FL setting Schedule Everyweek Everyday Schedule behavior

'0'-'0'(30h, 30h) Schedule Disable

'0'-'1'(30h, 31h) O Schedule Disable

'0'-'2'(30h, 32h) O Schedule Disable

'0'-'3'(30h, 33h) O O Schedule Disable

'0'-'4'(30h, 34h) O Once *Follow WD (Week setting)

'0'-'5'(30h, 35h) O O Everyday

'0'-'6'(30h, 36h) O O Everyweek *Follow WD (Week setting)

'0'-'7'(30h, 37h) O O O Everyday

ETX (03h): End of Message

Check code

BCC: Block Check Code

Refer to the section 4.5 “Check code” for a BCC calculation.

Delimiter

CR (0Dh): End of packet

11. Self diagnosis

11.1 Self-diagnosis status read

This command is used in order to read the Self-diagnosis status.

1) The controller requests the monitor to read Self-diagnosis status.

Header Message Check code Delimiter

SOH-'0'-'A'-'0'-'A'-'0'-'4' STX-'B'-'1'-ETX BCC CR

Header

SOH (01h): Start of Header

'0' (30h): Reserved

'A' (41h): Monitor ID

If the command should be sent to certain monitor only, the either of character ‘A’(41h) to ‘Z’(5Ah)

which is corresponding to monitor ID from No1 to No.26 should be set to this portion.

'0' (30h): Message sender is the controller

'A' (41h): Message type is "Command"

'0'-'4'(30h, 34h): Message length.

Message