Specifications

[Issue No.] GOT-A-0010-AB [Page] 26/41
[Title] List of Valid Devices Applicable for GOT1000 Series
[Date of Issue] Ver. AB: December 2014 (First Edition: September 2005)
[Relevant Models] GOT1000 Series
HEAD OFFICE : TOKYO BUILDING, 2-7-3 MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN
NAGOYA WORKS : 1-14, YADA-MINAMI 5-CHOME, HIGASHI-KU, NAGOYA, JAPAN
TECHNICAL BULLETIN
(2) Printable area
When using the report function of the GOT, the printable area varies according to the printer.
By the printer specifications, the trimming process is performed and some specified lines may not be printed.
(The trimming process adjusts image dimensions to a full printable area specified for the paper size, and does
not print the unprintable areas.)
When some areas are not printed, adjust margins and lines by using the report function of the GOT in
accordance with the printer specifications. (Refer to the figure below.)
Example) When the number of lines is set to 70, and the first line and 70th line are unprintable
The printable
area of
the printer
Some specified areas
are not printed.
Because areas are
unprintable, both lines
are not printed.
1
2
3
3
68
69
70
The printable
area of
the printer
Upper margin
Number of lines
Bottom margin
By the GOT (Report function),
adjust margins and the number
of lines so that the specified
area is within the printable area.
1
2
66
67
68
When some of lines are not printed for the report function of the GOT, configure the printer setting with no
trimming. Doing so may print the lines correctly.
(3) Paper jam
For the paper jam, remove the paper, and then execute the printing process again by using the GOT.
When the printing process does not start after the above actions, execute any of the following methods.
(a) Press the cancel button on the printer to stop the printing process, and then execute the printing process
again by using the GOT.
(b) Disconnect and connect the cable of the printer, and then turn on the printer again. (The printing process
starts again automatically.)
(d) Press the OK button on the printer to stop the printing process. Then execute the printing process again by
using the GOT.
(e) Press the cancel button on the printer. (The printing process starts again automatically.)
(4) Others
For some printers, the print enable/disable status notification signal (GS258.b3) may turn on before the
preparations for printing are not completed.
Check the preparations for printing and then execute the printing process.