Specifications

12
To Manually adjust the image:
1. Display a test pattern image on the monitor. This is the best way to observe
changes as you adjust the image. Alternatively, a stationary image may be
used, preferably one with small text or thin vertical lines.
2. Open the OSD menu by pressing the SEL/MENU button on the monitor.
3. Press < or > to select the Image Adjust menu, then press AUTO.
4. Press < or > to select Clock and then press < or > adjust.
5. Check the current setting. Increase or decrease the Clock setting to get
the optimum picture. If some noise or distortion is still visible in the centre
section of the test pattern, select Phase and press AUTO.
6. Adjust the Phase setting to optimise the displayed image. Close the phase
submenu by pressing SEL/MENU.
7. Select H-Position or V-Position and press AUTO.
Adjust the horizontal and vertical position so that the image is centred.
Its width and height should be the same as the visible width of the screen.
Close the phase submenu by pressing SEL/MENU.
8. Press SEL/MENU to close the OSD menu and save your changes.
If you are still not satisfied with the result, check the videocard is set to
native resolution the refresh rate is set to 60Hz, before repeating this
procedure.