System information
61
The following information is shown for each product on the list:
Product ID, including:
- name of the destination machine
- type of output module (PRINTS, LABS, BURNS)
- type of consumable
- print format
In the example, the name of the destination machine is CLICKqa, the service module
is PRINTS (therefore we know it is a product that can be printed instantly using
MITSUBISHI sublimation printers), the type of consumable is 15x20 and the print
format is also 15x20.
In some cases, the type of consumable and the print format may differ, as is the case,
for example, when printing 2 copies of 10x15 photos on a 15x23 consumable sheet.
In that case, the type of consumable would be 15x23 and the print format would be
2x10x15.
Description of the pick-up point
Due to the fact that different production destinations can be configured for each
product, it is important to make it clear to the operator which pick-up point is used
for each one.
This description may be the same as that shown to the end customer, or it may
be a shorter description. This is explained in detail further on in this section of the
manual.
When you press the „Add product‟ or „Edit product‟ buttons, the product configuration wizard
will start. The following sections will explain the steps in detail.
6.1.2.1 Production machine
The first step is to select the production machine to which the product will be sent.
According to the system settings, more than one option may appear. These could be the
Kioskgifts itself (in stand-alone mode), another Kioskgifts machine (as is the case in a Kiosk
isle), or a Click5000.