System information

APPENDIX DPSLab
APPENDIX DPSLab 31
5 Installation and configuration of the MIT_PBM_100
service
5.1 Introduction to the service MIT_PBM_100 and protocol
MIT_PBM_100
The MIT_PBM_100 service is a preconfigured and protected service for enable the
Dispatcher system to send orders to the PocketBook machine PBM, it install also the protocol
MIT_PBM_100 which communicates with the PBM machine.
5.2 Specific characteristics of Service MIT_PBM_100
 It uses MIT_PBM_100 protocol to communicate with PBM machine. See below it
specification.
 It is only enabled configure the working settings and the service publish, also the specifics
and others of the protocol (See below). The rest of settings are protected for preserving
the correct function of print.
5.3 Specific characteristics of the protocol MIT_PBM_100
As a protocol of the DPS system, its main characteristics are:
 It DOESN‟T accepts UNICODE.
 It DOESN‟T accepts images in any position, only horizontal.
 It only accepts jpeg images.
 It only accepts requests with one format at one time.
5.4 Software installation
The programme for starting the installation is the self-installing „MIT_PBM_100_SERVICE -
1.2.0- setup.exe‟ located in the software folder. Remember that the service is installed in the
SERVICES folder in the DPSLab installation directory.
This installer is the typical type used in DPSLAB installations, which is very intuitive and easy
to use.
It also installs the protocol MIT_PBM_100 version 1.2.0 with the installer „MIT_PBM_100 -
1.2.0- setup.exe‟. Remember that the protocol is installed in the MODULES folder in the
DPSLab installation directory.