System information
APPENDIX DPSLab
APPENDIX DPSLab 19
K. OPER ALIAS – The operator internal alias identifier of DPSLab for the format (in CM).
K. INCH OPER ALIAS – The operator internal alias identifier of DPSLab for the format (in
INCHES).
LAB. PRODUCT ID – Identifier of the laboratory for the format.
LAB. PRODUCT DESCRIPTION– Description of the format by the laboratory.
WIDTH – Width of the format in pixels.
HEIGHT - Height of the format in pixels
DPIs – The recommended DPIS for the format. The DPSLAB engine doesn‟t use this
data for internal processing, but this information is published by DPSLAB and is used for
some applications for picture rendering operations.
All the above fields are compulsory. The following are optional:
PRINT WIDTH – Width of the paper to be used to print the image in millimetres. This is
only used in some protocols. If not specified in the protocol, 0 can be used.
PRINT HEIGHT – Height of the paper to be used to print the image, in millimetres. This is
only used in some protocols. If not specified in the protocol, 0 can be used.
MEGAPIXELS – This value is for information purposes and specifies the size in pixels the
image should have in order to be printed in this format and to obtain an acceptable
quality.
3.2.1.10 Others
This tab specifies totally free properties, which are only textual, in order to provide the
protocol with additional free information. This information is sent to the laboratory where it
may be read. This section is optional.
3.2.1.11 SEND METHOD
For a service, it is necessary to specify the way in which the results of this processing will be
sent to the laboratories' systems as well as the protocol responsible for processing orders.
There are 4 possible types of sending when configuring a service:
Delivery - The order is not sent automatically, but instead waits for recording on a
memory card or on a CD. When this happens it is deemed to be "sent".
LAN - Enables a route within the network to be specified, by which orders are sent for
processing.