System information

APPENDIX DPSLab
APPENDIX DPSLab 16
Horizontal The protocol requires all the photos to be in a horizontal position. If any
are not, they will be rotated.
Vertical The protocol requires all the photos to be in a vertical position. If any are
not, they will be rotated.
o Only JPG: If this box is checked the protocol only accepts image files in JPG format.
If not, it accepts all the formats specified in the "others" field.
o Others: This specifies the image extensions that are not automatically coverted to
JPG, for sending to the laboratory, if the "only JPG" box is not checked.
One extension per line must be written with no dot before it, as shown in the image.
o Type of adjust to format dimensions: There are three options for adjusting the
image to the laboratory format when the image size is larger than the formats:
o Cut - the image is reduced until one of the sides coincides with one of the
dimensions of the format. The other dimension, which will always be bigger than
that of the format, will be cut proportionally on both sides.
o Fit Sides - The image is made smaller so that both dimensions are within the
format. One of them is the same as one of the format, and the other will therefore
be smaller than the format. In this case, there will always be a white edge on the
paper when printing.
o Max. Size Factor - This reduction is only applied when the image size is larger
than the value in the field Opt. Size Disk (in KBytes) and if the image dimensions
are larger than those of the format after applying the Max. Size Factor. This
means that the image is changed providing that the dimensions of image x Max.
Size Factor > format dimensions.
This type of adjustment is used to reduce the weight of images without
reducing their quality, in order to be able to apply it when sending by
FTP, for example.