System information

APPENDIX DPSLab
APPENDIX DPSLab 13
The add service button behaves differently depending on whether there are services already
configured or not.
If there is no service configured it creates an empty service, without a protocol or sending
mode.
If a service has there already been created, DPSLab presents a list of the services already
configured and allows you to select the one to be copied or else create an empty one, as
shown in the following screen:
 The "Copy Selected" button will create a new service by COPYING THE WHOLE
configuration of the the service selected, including internationalisation (Translations),
taking us back to the settings screen to personalise the new service.
 The "Create Empty" button creates a new empty service, without protocol or sending
mode.
 The "Cancel' button returns you to settings without doing anything.
In both cases, of creation, the service is created with the "LABS<N>", where <N> depends on
exisiting ones, identifier and the newly created suffix (*). <N> is assigned sequentially.
The ID field identifies the service.
Each one of the sections of a service configuration is described below.
NOTE
There is a series of parameters, which are specifications of the actual protocol, which have
been deactivated to avoid wrong configurations and therefore a protocol malfunction. They
have been left visible to the user to so that they can be easily read if they need to be known.