System information

APPENDIX DPSLab
APPENDIX DPSLab 7
The services in "error" status in DISPATCHER must be relaunched manually by the operator,
and the DPSLab module will treat them as if it were processing them for the first time,
beginning from zero with each one of them.
If during the sending of a job the machine is powered off, the job will remain in the
“EXECUTING” or the "BATCH EXECUTING" status in DISPATCHER, and when the machine
is powered up again, the DPSLab module will check the files sent until that moment and will
continue with the one after the one last one sent before the power-off, following the same
procedure as for retries through communication failures, explained above. This is tru for the
FTP and LAN transfer methods. It depends on the protocol when the transfer method is
SELF
The PAUSE button in Dispatcher is effective in the send phase in some protocols, for LAN
and FTP is not possible, to eliminate an order from the print queue of the DPSLab module,
the module must be switched off and the order removed from DISPATCHER when it appears
in error status after a few seconds.
2 Installation
2.1 Software installation
DPSLAB-X.X.X-setup.exe is the DPSLab installer. Double clicking on it starts the installation.
The following screens are typical of an automatic installation system and are very intuitive:
 Welcome and introduction screen
 Selection screen for the modules to be installed. In this case there is only the DPSLab
application.
 Request for the installation directory. The installer proposes the preconfigured directories,
if these have already been created. (More information on this in the Flexilab manuals)
 After the directory has been selected, the installation process begins after clicking on
"install" and a screen shows the progress of the installation.

 Some versions could not be compatible with previous versions. The installation
application could ask for confirmation before delete any previous settings of the DPSLAB
service module.
Follow the instructions that appear on the screen. After the entire installation process has
ended, a concluding screen will appear. Click on “close” to complete the installation.
NOTE
At least one protocol must be installed for DPSLAB to be configured correctly.
At least one DPSLAB service must be configured.