System information

APPENDIX DPS PrintServer
APPENDIX PrintServer
configuration is applied to every MPU Sorter attached to the system.
The fields configurable regarding of the MPU Sorter are the following.
1.1.30 Balanced
This setting is ignored by PrintServer when printing with an MPU Sorter.
1.1.31 Sorting
This option determines if the MPU Sorter starts printing the first picture or the last one.
 Ascending: The MPU Sorter will start printing the first picture.
 Descending: The MPU Sorter will start printing the last picture.
1.1.32 Full belt mode
The possible values:
 STOP: MPU Sorter will stop printing until the stack is removed from the belt by the
operator (only the stack on the sensor it‟s needed to be removed).
 MOVE: MPU Sorter will move the belt when it gets full. The first stack will fall in the
belt tray and the MPU Sorter will keep printing.
1.1.33 Beep on full belt
When this option is checked, the IT5000 will beep when the belt gets full.
1.1.34 Number of stacks
This option is used to choose how many stacks are placed on the belt. It‟s possible to choose
between 2 or 3 stacks. Depending on this number the capacity of the belt will vary between
110 (2 stacks) or 165 (3 stacks) photos.
1.1.35 Custom Backprinting information
It allows to set a custom short information to be shown in the backprint, like the shopname,
per instance. Maximum length is 19 characters for this field.
1.1.36 Recommended configuration
To achieve an optimum performance, Mitsubishi recommends using the following
configuration of PrintServer:
 Full belt mode: MOVE if the MPU Sorter is unattended, otherwise STOP.
 Beep on full belt: Activated
 Number of stacks: 2
MITSUBISHI RECOMMENDS:
Do not use used paper or ink from another printer. The MPU Sorter unit performs better if
both printers have the same amount of remaining copies. Please change also paper roll
when ink cassette is exhausted.