System information

APPENDIX DPS PrintServer
APPENDIX PrintServer
1.1.26 Requirements and compatibility
To be able to use the MPU Sorter it‟s mandatory to have an IT5000 with a Flexilab ClickPro
software version 2.5.0 or higher.
In order to achieve the best results, use an IT5000 HW4 version, or higher, and plug in the
MPU Sorter directly with the supplied USB connector. It‟s advised not to use and USB
extender.
The MPU Sorter unit is compatible with Flexilab systems using PT6000, PT7000 or MT1E
machines connected in Order Terminal mode to an IT5000 working with ClickPro software
version 2.5.0 or higher.
Installation
Before connecting the unity to the IT5000, please check that you have a Flexilab Click Pro
2.5.0 version or higher and shut down all applications using the Monitor Manager.
Once the MPU Sorter is plugged in, please read thoroughly the on-screen instructions in
order to install correctly the MPU Sorter unit.
Once the installation is accomplished, reboot the system in order to let the changes be
applied.
To check the installation has been performed correctly, please verify that the MPU Sorter is
shown now in the DispatcherAdmin screen. It must be shown as a red frame framing the
contained printers.
Both printers are differentiated as the UPPER printer and the LOWER printer.
MITSUBISHI RECOMMENDS:
It‟s necessary to calibrate the printers contained in the MPU Sorter in order to achieve an
optimum result regarding to printing quality. Please refer to the previous chapter to get more
information about printer calibration.
Working modes
A MPU Sorter unit must be always attached to an IT5000. The MPU Sorter is able to print
local Click5000 orders (working as a single printer) and other ones coming from order
terminals (working then as a central high production machine).
These 2 printers belong to the same
MPU Sorter.