System information

APPENDIX DPS PrintServer
APPENDIX PrintServer
Quick calibration has to be chosen only if you have performed a full calibration before. Full
calibration will provide the best calibration for your printer, but it will require 5 prints in
10x15cm – 4x6 inch. Quick calibration can be done with only 1 print, and it is intended for
everyday adjustment, but it is based on a previous full calibration. Quick calibration is only
able to correct small deviations, but will work fine on most of the cases. When quick
calibration does not perform well, it‟s time to proceed with a full calibration again.
In this chapter, only full calibration will be explained, because it has more steps. If you
understand full calibration you will be able to perform a quick calibration as well.
Click „Continue‟ to start the calibration process. You will be prompted to connect Eye-One
device. Connect it and click „Ok‟ to continue. Calibrator application will be launched.
CALIBRATOR & PRINT PROFILER ACTIVATION CODE
When Calibrator is launched for the first time you will be prompted to insert an activation
code. This code can be found inside the Eye-One case in a paper labelled “Calibrator Unlock
Code”. Please, note that the unlock code is case sensitive.
Next you will be prompted for device calibration. Follow the shown instructions and finally
click „Ok‟.