System information
APPENDIX DPS PrintServer
APPENDIX PrintServer
1.1.21 Calibrating the printer
There are two ways to calibrate the printers. In case of having the Eye-One calibration kit
please proceed with the calibration mode using Eye-One. Otherwise, proceed with visual
calibration.
1.1.21.1 Visual Calibration
NOTE
If you have an Eye-One calibration kit please go to the next chapter 5.3.1.2, which refers to
the calibration using an Eye-One.
Start the calibration wizard and when you are asked whether you have or not and Eye-one
device choose the option “No, I don‟t”.
At the beginning of the wizard an image with a set of greyish patches will be printed, as
shown in the figure, divided into four groups.
Once printed, select the most neutral grey box (with no colour cast) of each group (area) and
enter the associated number in the corresponding boxes. In the first step is quite normal to
leave the values to 0, since none of the patches are closer enough to the desired gray, but it
will depend on the printer. Sometimes, leaving the values to 0 and pressing „Continue‟ makes
the decision easier by reducing the distance between patches.