System information

APPENDIX DPS PrintServer
APPENDIX PrintServer
After printing one or more patterns you will have to read them with the device. Please, repeat
the following steps for each printed pattern:
1. Put the printed target on the reading support as
shown, attaching it with the upper black plastic support.
2. Put the Eye-One
device on the black
plastic slider support
as shown. Eye-One
device must slide freely in horizontal direction
and the transparent plastic guide must slide in
vertical direction. Make sure the printed target is
not too close to the left because the reading
process must start on a white surface.
3. Slide Eye-One and transparent support to the top
left, as shown. Eye one device must be placed aligned
with the first row of patches and pointing to a white
background on the left of the first patch. When prompted
by the software, click on the Eye-One operation button
and leave it pressed. Then, you will hear a “beep” signal
(If you don‟t hear a beep signal, because maybe your
system does not include internal speaker, just wait a
couple of seconds). In this moment slide the Eye-One
device horizontally to the right until reaching the end of
the patches row. Try to move the reading device in a
constant speed. With some practice you can read a 4x6
print in less than a minute (45-50 seconds).
4. Move down the transparent plastic sliding support,
aligning the plastic support hole to the next row, and
return the Eye-One device to the left as shown. Then
repeat the process until finished.