System information

APPENDIX DPS PrintServer
APPENDIX PrintServer
a. In the „Colour Table‟ group in the „Colour‟ drop-down list box, select the
„Printer Colour‟ option. Do not use the „Flat‟ colour table. The convention of
these names depends on the printer model.
b. In the „B/W‟ drop-down list box, always leave the „Printer Colour‟ option
selected.
c. Set „Noise Reduction‟ to „off‟.
d. Set „Sharpness‟ to 4.
e. Set „Superfine mode‟ to „off‟.
f. Set „Gamma Colour‟ to „Photo‟.
g. Set „Mode‟ to „normal‟.
6. The „Apply Colour Matching‟ option in the „Colour Matching‟ panel must be
unchecked.
CP9550DW-S/CP9600DW-S using ICC profile
1. Check that the Colour Correction group has the „Advanced‟ option checked.
2. Press the „Set-up‟ button.
3. Check that NO CPD curve is loaded. The Flat line must be selected.
4. Press the „Exit‟ button.
5. Press the „Parameters‟ button on the „Detected Printer list‟ to show the Parameters
form.
a. Select the „Flat‟ option in the „Colour Table‟ group in the „Colour‟ drop-down
list box. Do not use the „Printer Colour‟ colour table. The full option naming
convention depends on the printer model.
b. In the „B/W‟ drop-down list box, leave the „Printer Colour‟ option, if there is no
special colour profile for that option.