System information

APPENDIX DPS PrintServer
APPENDIX PrintServer
Load default
Classic colour correction settings
This chapter refers to the classic colour corrections. It is highly recommended to use the new
iQ Image quality management system (refer to chapter 5) instead classic settings. However,
the system is predefined in classic colour correction in order to allow backward compatibility
and it is possible to keep using the classic system instead.
It is important to take into consideration that old Easy Colour Adjustments have been
removed from the Classic colour correction options because they have been embedded on
the new iQ Image quality management system as the new concept “Visual Calibration”.
(Please, refer chapter 5 for more details).
In Classic colour correction mode, after the printer is detected, some colour and quality set-up
can be carried out. A choice between using CPD colour adjustment files or ICC profiles is
possible. It is very important to set up the system according to your choice.
ICC profiles are automatically applied to each printer and it is the default Mitsubishi
recommended configuration.
IMPORTANT NOTE – ICC COMPATIBILITY
Now DPS PrintServer supports standard ICC profiles and special Mitsubishi ICC profiles.
Mitsubishi ICC profiles follow a new design and are not compatible with the old ones, so, ICC
profiles from older versions than DPS PrintSever 5.6 are not longer compatible.
CP9550DW-S/CP9600DW-S/CP9800DW-S/DP9820DW-
S/CP70/CP707 using CPD file
1. Check Colour Correction group has the „Advanced‟ option checked.
2. Press the „Setup‟ button.
3. Check that the CPD default curve for CP9550DWS is loaded. The grey curve is a
guide if one is needed to make small adjustments, in order not to stray too far from
the current standard CPD adjustment for the printer.
4. Press the „Exit‟ button.
5. Press the „Parameters‟ button on the „Detected Printer list‟ to show this form.