System information

APPENDIX DPS PrintServer
APPENDIX PrintServer
1.1.15 Full belt mode
This setting only applies to MPU unit, it indicates what is the action that the application must
do when a stack has reached the end of the belt. The values can be:
 STOP: PrintServer will stop printing with MPU till the stack is removed from the belt
by the operator (only the stack over the sensor it‟s needed to be removed).
 MOVE: PrintServer will move the belt so the first stack will fall at belt tray.
1.1.16 Beep on full belt
This setting only applies to MPU unit, when checked PrintServer will emit a sound when a
stack has reached the belt end.
1.1.17 Number of stacks
This setting only applies to MPU unit. It allows configuring the number of the MPU output
stacks on the belt.
1.1.18 Custom backprint information
See MPU related information in this manual further on.