System information

APPENDIX DPS PrintServer
APPENDIX PrintServer
Print Areas
In this section is possible to set the default parameters of real print area and white border
dimensions depending on printer model (and printing quality in some cases).
The final picture data being sent to the printer is always slightly bigger than the real print area
size, in order to compensate possible deviations of the thermal head position respect the
paper position. This helps to ensure that, even when the paper is slightly shifted to one side,
there‟s not any edge of the paper without picture information being printed.
By default, the print area is equal to the picture data dimension in terms of pixel size. (width
and height). This data („Printable width‟, „Printable Height‟) can be adjusted in this screen.
Also the dimensions of the white frame for white border prints can be adjusted here.
NOTE
It‟s possible to adjust different offset per each printer of the same model being installed in the
same system, but not in this screen. It‟s required to access to the individual printer parameter
menu and change horizontal and vertical offset. This is useful when printers of the same
model are showing differences between their respective printing position offsets.
IMPORTANT NOTE
Cutting formats (10x15x2, 11‟5x15x2) do not support white border
Non printable area
Limits of printable area
White
border
Choose printer, format and
quality
Adjustment of printing
area
Keep proportions
White border
adjustment
Refresh screen
Save
changes
Exit