System information

APPENDIX DPS PrintServer
APPENDIX PrintServer
 Number of copies near end will generate an incident when reaching the configured
number.
 Save and Exit to apply changes.
 Exclusive Formats. Activating this option CP9600DW-S will work with its own formats.
This helps to avoid CP9600DW-S printing standard 10x15 cm (6x4 inc) or 15x23 cm (6x9
inch) sizes when the printer is attached to a system together with other printers like
CP9500DW-S also using that media size. Due to HIGH QUALITY and SLOW SPEED of
CP9600DW-S printer, it is preferable to reserve this printer for special jobs like Studio
pictures, where high quality is a must. When this option is checked and the user wants to
send a request to that printer, special paper size must be chosen from the list of available
paper size 10x15 cm (6x4 inc) or 15x23 cm (6x9 inch).
 Mirror Mode. Activating this option the image will be inverted (from left to right), producing
a mirror effect. This option is deactivated by default.
 Overcoat. This option enables the printing of an overcoat layer on the picture. It is
activated by default.
 White border. This option is used to adjust the position of the picture over the white
border when this option is selected to print pictures. This is useful when the print out of the
printer is slighty shifted respect the upper/lower or right/left edges.
The target is to have the same thickness of white border for all sides. This value is
settable in fractions of 0.1 millimetres and can also be positive or negative.
The default values are usually the best, but the operator can vary these parameters to
improve the performance of the printer on a printer-by-printer basis.
NOTE
Do not change the Colour Table unless ICC profiling applies.
In this case, „Flat‟ or „No tables‟ will be automatically selected
NOTE
For CP9550DW (A) choosing FineDeep image quality, will make the printer print in SuperFine
mode
Restrictions:
With the format 10x15x2 based on paper-cut, white edge cannot be implemented.
When a plotter printer is selected, the “Parameters” screen shows special configuration
options that only apply to the plotter.
 Advanced interpolation. This option allows resizing the plotter images for the format
PLOTTER. This option is disabled by default.
 Max MegaPixels. This option allows specifying how many megapixels will be used when
resizing to format PLOTTER. It is only applied when advanced interpolation is activated.