Specifications

Kiosk Kiosk Kernel Operator Manual
March 2006 - v2.2
3.2.5 Coin Counter
This section controls the change inside the coin hoppers.
This button only appears if the optional coin machine is connected to the
system and the optional hardware checkbox is checked.
If it is hidden, and there is a coin mechanism, make sure that it is properly
connected and powered up, and restart the program.
• Procedure for counting coins in the hoppers
1. Insert the coins to be counted into the hoppers.
2. Press the “Count Coins” button of the hopper to be counted.
Hopper 1 (Top); Hopper 2 (bottom)
3. Insert the coins back into the hoppers.
NOTE
After counting the hopper coins, the amount will not be increased with the coins counted, the final
amount will be directly the result of this count.
• Coin Value
This figure shows the value of the coins in the hopper. This must be configured by the
supervisor and must match the real value of inserted coins. It is necessary to setup the coin
value before counting.
• Coin Level
This figure shows the number of coins in each hopper after the “Count Coins” button has
been pressed. Whenever the system gives out change or a customer inserts a coin of the
same value the coin level is refreshed automatically.
• Hopper amount
This figure shows the total money amount in each hopper after the “Count Coins” button has
been pressed. Whenever the system gives out change or a customer inserts a coin of the
same value, the hopper amount is refreshed automatically.
• Total hoppers
This figure shows the total sum of both Hopper amounts after the “Count Coins” button has
been pressed. Whenever the system gives out change or a customer inserts a coin of the
same value the total amount is refreshed automatically.